F150 console swap
 

Posted this in a Ford forum but who knows maybe i'll get lucky here.

Anyone here ever swapped out a bench seat/jump seat for a floor console in an F150? I have a 13 f150 i'm trying to do it to but I've run into a problem.

Do a search on this site http://www.f150forum.com/ .

There were some guys doing the swap there awhile back.

what problem have you ran into?

What color is your F150, DC?

Dinny

There's an amp under my jump seat that sits between the aluminum bracket the seat mounts on.

With the amp there it doesn't allow enough clearance for a floor console to sit down on the bracket.

There's like 500 threads on the f150 forums about it but I haven't seen a single one that mentioned the amp being in the way so i'm rather confused how people got around it.

Considered relocating the amp but there isn't much room under the driver and psg seats

It's two tone, Pearl White is the main color and a goldish kind of color on the bottom.

I actually don't like the color scheme. I wish it was charcoal gray or blue

Can you use some spacers to get the height you need?

Not sure how I would do that. The console bolts in from the side. I'd have to fabricate some kind of base for it.

Not only that but even if I could do it it would make the console sit at least 2 inches higher which isn't optimal arm rest height.

Sent from my SCH-I545 using Tapatalk

I was thinking this. Get some rubber bumpers and longer bolts/screws if you can (not sure how those are held down in a Ford).

Pack of 10 of these are like $3-4

https://d2pbmlo3fglvvr.cloudfront.ne...uL3vncpIx_.JPG https://www.zoro.com/value-brand-bum...34/i/G7504052/

Just saw your post on it bolting in from the side. Could you drill the console and bracket to make it bolt in from the top instead?


Also, try getting in touch with the guy here: http://www.f150forum.com/f38/middle-...e-swap-146672/

could you mount the amp inside the console?

One thing I was thinking about... maybe you could screw/bolt bumpers to the bottom of the console, then drill new holes in the side to bolt it up to the existing side bracket? Might do what you want. I've always installed amps under the back seat or on the back wall if a reg cab.

Well at least it isn't black.

Car stereo technology has gone too far. They should have gotten to the Pioneer Super Tuner and quit. Although it has been a while since a machine ate my favorite R.E.O. tape.

One more question. Do you have TimBone on ignore? (asking for a friend)

Dinny

This is a good suggestion actually and it may be the easiest solution.

I could cut the bottom out of the console to leave room for the amp and then make some kind of new base for the inside of the console to protect the amp.

Thanks

Don't think so. Don't believe I have anyone on ignore actually