|
Go to a hardware store and get a grounding rod and a sledge hammer. Get the clamps that fit the rod too, you'll use those to run separate wires. Get 100ft of 14 ga green wire and an auger bit to fish the wire through your walls. get some wall patch to close those holes. If you want to be fancy and go code, use conduit to fish you wires in. You'll need to identify exact spots you need to ground, exact outlets. You'll need to pull your outlets from the boxes, so, you may need some new outlets to replace the old ones. Use the same whit/black connections but cut off the green wires and use a wire nut to insulate them from ever touching anything again. Make sure you get that rod at least 3 feet into the ground and make sure you shut off the breaker to each circuit you are working. You get the idea?
__________________
The Greatest
|