Misc Refrigerator Question

CaliforniaChief · 08-29-2011, 04:10 PM

Hey guys and gals.

For the past week or so, our water volume has been lower on the dispenser of our Maytag Performa Refrigerator. My first instinct was to change the filter. Went and bought a filter, installed it, and still low flow. I pulled the fridge away from the wall and verified that at least from the wall to the filter, there's no sediment/blockage. I took a look at the area connected to the two solenoids in the back but was afraid to start pulling tubes out of places. Since I don't have Haley's finger to reach into the tube, what should I do?

Call a professional?

**Donger** · 08-29-2011, 04:11 PM

Shoot it?

vailpass · 08-29-2011, 04:28 PM

Do you have a little screen filter in the water supply line itself? Not your main filter but the small sediment screen in the line.

**Ming the Merciless** · 08-29-2011, 04:31 PM

if its hooked up via a 1/4 hose to a shut off under your sink in your angle stop or copper line..

edit:

sounds like u might have done this already hmm

**Ming the Merciless** · 08-29-2011, 04:35 PM

Make sure if u have a self piercing shutoff valve that:

Quote:

if you have a self peircing one that it has properly pierced the pipe (crank it all the way in again and back it out.)

Quote:

Clogged shut off valve, kinked line, clogged fill valve, tired filter can allow low pressure fills.

Quote:

First thing I would do is disconnect the water line from the back of the refrigerator and run the water full blast in to a bucket/out the window/ in the sink or whatever you can do. With a 1/4" water line you should be able to spray the water 20 feet out if your flow is decent. If its going that far, the problem is somewhere on the refrigerator. If its not spraying out real hard you either have low pressure or something restricting the flow. If you have a clamp on saddle valve that might be the problem. Sometimes the pin that pokes the water line will not retract out of the hole, leaving you with a very slow water flow. I don't like to use those, but if I have to I'll drill a 3/16" hole in the line so even if the pin does stick there will be no effect on water flow. Another thing you will want to be sure of is the water line from the wall to the refrigerator is not kinked, or was not kinked when the refrigerator was pushed back to the wall.

(source: google)

**Bwana** · 08-29-2011, 04:38 PM

Quote:

Originally Posted by Donger

Shoot it?

PM frazod

**Bugeater** · 08-29-2011, 04:39 PM

Yeah, check the piercing valve if it has one, I've had those clog up before.

**Ming the Merciless** · 08-29-2011, 04:41 PM

Quote:

Originally Posted by Bugeater

Yeah, check the piercing valve if it has one, I've had those clog up before.

yep

Quote:

If you have a needle type self-piercing type shut-off valve, those tend to clog up, its better to replace them with a 1/4" shut-off valve type.

Poppin up alot in teh google

CaliforniaChief · 08-29-2011, 04:56 PM

Argh, I'm so bad at this stuff. I'll see if I can upload a pic of it later. Thanks, guys....

**Ming the Merciless** · 08-29-2011, 06:54 PM

Just to confirm -

did you pull out the fridge, shut off the water under the sink, unscrew the 1/4 hose from the back of the fridge and then turn the water back on (point the business end into a bucket or down the sink if you have enough hose) to see if everything up until the fridge is working?

It should shoot an extremely powerful jet of water. I think you did this already from your post but just wanna be totally sure.

Dante84 · 08-29-2011, 07:01 PM

Quote:

Originally Posted by CaliforniaChief

Hey guys and gals.

Is it running?

FYP

CaliforniaChief · 08-29-2011, 07:41 PM

Quote:

Originally Posted by Pawnmower

Just to confirm -

did you pull out the fridge, shut off the water under the sink, unscrew the 1/4 hose from the back of the fridge and then turn the water back on (point the business end into a bucket or down the sink if you have enough hose) to see if everything up until the fridge is working?

It should shoot an extremely powerful jet of water. I think you did this already from your post but just wanna be totally sure.

Yes. I unscrewed the hose from the tubes headed into the fridge and turned the water up to full strength and had a very strong flow headed into the bucket. I'm confident the problem is somewhere in the fridge/waterline. Oh, and I've noticed the ice cubes seem smaller too.

**Renegade** · 08-29-2011, 07:43 PM

I think it is the cabin air filter.

**Bugeater** · 08-29-2011, 07:52 PM

Quote:

Originally Posted by CaliforniaChief

Yes. I unscrewed the hose from the tubes headed into the fridge and turned the water up to full strength and had a very strong flow headed into the bucket. I'm confident the problem is somewhere in the fridge/waterline. Oh, and I've noticed the ice cubes seem smaller too.

Huh, that's what started happening with our ice maker as well. We just quit using it and we buy bagged ice now.

MOhillbilly · 08-29-2011, 07:56 PM

Shoot it.

08-29-2011, 04:10 PM
CaliforniaChief #RIPAce Join Date: Jan 2009 Location: So Cal Casino cash: $10615899	Refrigerator Question Hey guys and gals. For the past week or so, our water volume has been lower on the dispenser of our Maytag Performa Refrigerator. My first instinct was to change the filter. Went and bought a filter, installed it, and still low flow. I pulled the fridge away from the wall and verified that at least from the wall to the filter, there's no sediment/blockage. I took a look at the area connected to the two solenoids in the back but was afraid to start pulling tubes out of places. Since I don't have Haley's finger to reach into the tube, what should I do? Call a professional?
Posts: 17,457

08-29-2011, 04:11 PM	#2
Donger "Think BOOM!" Join Date: Nov 2003 Location: 33.675° N 106.475° W Casino cash: $6819900 VARSITY	Shoot it? __________________ I think the young people enjoy it when I "get down," verbally, don't you?
Posts: 191,135

08-29-2011, 04:28 PM	#3
vailpass Psycho Bag Of Squanch Join Date: Sep 2001 Casino cash: $9594244	Do you have a little screen filter in the water supply line itself? Not your main filter but the small sediment screen in the line. __________________ “Education is a weapon whose effect depends on who holds it in his hands and at whom it is aimed.” Joseph Stalin
Posts: 69,591

08-29-2011, 04:31 PM	#4
Ming the Merciless Emporer of Mongo Join Date: Apr 2010 Location: Milky Way Casino cash: $-592444	if its hooked up via a 1/4 hose to a shut off under your sink in your angle stop or copper line.. edit: sounds like u might have done this already hmm __________________ ---- 2018 Adopt-A-Chief : Chris Conley 2017 Adopt-A-Chief : FRANK ZOMBO Click here-->*The Holy Chiefsplanet Lexicon ** Last edited by Ming the Merciless; 08-29-2011 at 04:37 PM..
Posts: 46,212

08-29-2011, 04:39 PM	#7
Bugeater The Maintenance Guy Join Date: Sep 2005 Location: Renovated Bugeater Estate Casino cash: $3992680	Yeah, check the piercing valve if it has one, I've had those clog up before.
Posts: 70,546

08-29-2011, 04:56 PM	#9
CaliforniaChief #RIPAce Join Date: Jan 2009 Location: So Cal Casino cash: $10615899	Argh, I'm so bad at this stuff. I'll see if I can upload a pic of it later. Thanks, guys....
Posts: 17,457

08-29-2011, 06:54 PM	#10
Ming the Merciless Emporer of Mongo Join Date: Apr 2010 Location: Milky Way Casino cash: $-592444	Just to confirm - did you pull out the fridge, shut off the water under the sink, unscrew the 1/4 hose from the back of the fridge and then turn the water back on (point the business end into a bucket or down the sink if you have enough hose) to see if everything up until the fridge is working? It should shoot an extremely powerful jet of water. I think you did this already from your post but just wanna be totally sure. __________________ ---- 2018 Adopt-A-Chief : Chris Conley 2017 Adopt-A-Chief : FRANK ZOMBO Click here-->*The Holy Chiefsplanet Lexicon **
Posts: 46,212

08-29-2011, 07:43 PM	#13
Renegade Just Lurking Join Date: Feb 2009 Location: Ozark Mountain Country Casino cash: $-1872096	I think it is the cabin air filter.
Posts: 2,121

08-29-2011, 07:56 PM	#15
MOhillbilly Mama Tried Join Date: Dec 2002 Location: Missouri Casino cash: $9949903	Shoot it. __________________ True Son of Liberty
Posts: 23,371

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode