| Chiefaholic |
09-08-2004 07:45 PM |
Quote:
Originally Posted by JennyGump
I was in a home improvement mood today when I went to Lowes. I purchased, among other things, a new doorbell button. My previous doorbell button had actually fallen out, but you could still push the springs and the thing would ring.
Well, when I unscrewed the old button unit, I carefully took note that there were four wires, red, black, green, and yellow, however, only the black and red wires were hooked to the old unit. One on each side.
So, when I installed the new unit, of course it doesn't work. :banghead:
Now I am wondering what I did wrong. Any ideas?
|
Hmmmmmmm......red, black, green, and yellow, huh? Sounds to me like you're installing a doorbell to your phone jack. Try that little button by the front door instead.... :p
Seriously though, all you need is two of the wires. Check to make sure a breaker hasn't tripped, then try the same two wires you started with. You can't install them backwards, so don't worry about which wire goes to which side. As long as you have the two wires to complete the circuit is all that matters. |
