Home and Auto Handy-Man Corner - Page 8

**Iowanian** · 09-24-2004, 08:25 AM

I'm tired of bad Chiefs news.....

I thought it would be a good idea for a thread on the Handy-Man.

Do you have any Home remedies, gadgets you've made, advice on car repair, home maint, sollutions to kill weeds in your yard, bugs in your garden?

Use Coke to clean your batteries? That type of stuff.
Home made floor dry?

**Iowanian** · 11-15-2005, 03:49 PM

Garage door opener dilema.

Ok Tool Men...
I've got a garage, it has a door, it has a newer automatic opener.
It was working fine, and then one day, wasn't. I can push the button(remote or one inside) and it opens just fine, when I push the close button, it comes down about 3/4 the way, goes back up and clicks/blinks 3 times.

Suggestions?

**BigRedChief** · 11-15-2005, 03:57 PM

Quote:

Originally Posted by Iowanian

Garage door opener dilema.

Ok Tool Men...
I've got a garage, it has a door, it has a newer automatic opener.
It was working fine, and then one day, wasn't. I can push the button(remote or one inside) and it opens just fine, when I push the close button, it comes down about 3/4 the way, goes back up and clicks/blinks 3 times.

Suggestions?

On the back of the unit there is a reset button. Try it.

Redo the code and syncronize the unit.

Have you got an outside keypad to manually enter a code in?

Dinny Bossa Nova · 11-15-2005, 04:01 PM

Quote:

Originally Posted by Iowanian

Garage door opener dilema.

Ok Tool Men...
I've got a garage, it has a door, it has a newer automatic opener.
It was working fine, and then one day, wasn't. I can push the button(remote or one inside) and it opens just fine, when I push the close button, it comes down about 3/4 the way, goes back up and clicks/blinks 3 times.

Suggestions?

Three, off the top of my head.

Check to make sure all of the rollers are in the track, and aligned properly in the mounting brackets on the door panels.

If so, try keeping the button pressed in the entire travel of the door going down. See if it makes it through the snag-spot.

If not, press the button and get to the door before it snags, and "assist" it through said snag-spot.

All I gotfernow.

Dinny

**Iowanian** · 11-15-2005, 04:03 PM

If I hold the button from inside, it will close. If I don't hold the button through the cycle, it won't.

It does have an outside entry pad, but I don't think I've ever used it. I'll check for a reset button, but don't have a clue as to redoing codes.

Dinny Bossa Nova · 11-15-2005, 04:08 PM

BRC had steps 4 and 5.

They require some uh, well... er you know, probably a ladder, and some uh,

I got nothin'

Dinny

**Iowanian** · 11-15-2005, 04:10 PM

Ladder not required....I can stand in my boat which is taking up the whole thing, which gets to the problem....

To Do
21."get the garage door fixed and open for use by the family before snow falls"....oops.

Dinny Bossa Nova · 11-15-2005, 04:16 PM

At the risk of a good callin' out, you might be suffering from what we in the "industry" call a defective or worn-out garage door opener.

Dinny

**Iowanian** · 11-15-2005, 04:22 PM

Its possible, but though I bought hte house in June, and it wasn't clarified as to the age, I don't think the opener is very old....I'd wager less than 5 years. What is the average life expectancy?

**Baby Lee** · 11-15-2005, 05:09 PM

1. Loosen the door from the opener [there should be a quick release on the chain/gear] and manually run it through the problem area, see if there's a palpable snag.
2. If you have the electric eyes, make sure they're not getting misaligned or obstructed by the travel of the door.
3. Check and see if your opener has a sensitivity setting. If so, open it up a little.
4. Check your manual and see if the '3 blink' is a specific problem code.

Dinny Bossa Nova · 11-15-2005, 05:09 PM

I honestly don't know what the life-expectancy, but I'm sure it's tied to the quality of the unit.

If you can't find a snag in the track/roller thang, be aware there is a wide gray area between completely dead and working properly.

If the reset/reprogram doesn't solve it, you are likely looking at some new hardware.

And of course, the lowest price is not always the greatest value.

Dinny

11-15-2005, 05:11 PM

Your tension spring is broken.

Check the two springs on the roller above the door. One of them is broken.

Do not try to repair this yourself.

Call a professional.

**Baby Lee** · 11-15-2005, 05:13 PM

Quote:

Originally Posted by Phobia

Your tension spring is broken.

Check the two springs on the roller above the door. One of them is broken.

Do not try to repair this yourself.

Call a professional.

A little premature, no? Don't know if he has tension spring or running/roller spring. Also, a bad tension spring would produce more problems raising than lowering.

11-15-2005, 05:15 PM

Quote:

Originally Posted by Baby Lee

A little premature, no? Don't know if he has tension spring or running/roller spring. Also, a bad tension spring would produce more problems raising than lowering.

I dunno. I've run into 3 of these situations in the past year. I didn't pay much attention to the symptoms but from what I absorbed there's a match. Most newer doors have the roller tension springs.

**Baby Lee** · 11-15-2005, 05:18 PM

Quote:

Originally Posted by Phobia

I dunno. I've run into 3 of these situations in the past year. I didn't pay much attention to the symptoms but from what I absorbed there's a match. Most newer doors have the roller tension springs.

If there'd be mention of the opener laboring more than usual, or problems on raising, I'd be exploring that too. But this smacks of a safety/obstruction/electronics problem. Something's telling it there's something in the way.

FAX · 11-15-2005, 05:21 PM

I have it on good authority that boogers will serve as caulk when you're in a pinch. They're oderless too.

FAX THE INNOVATIVE

09-24-2004, 08:25 AM
Iowanian Supporter Join Date: Aug 2000 Location: Utopia Casino cash: $1798454	Handy-Man Corner I'm tired of bad Chiefs news..... I thought it would be a good idea for a thread on the Handy-Man. Do you have any Home remedies, gadgets you've made, advice on car repair, home maint, sollutions to kill weeds in your yard, bugs in your garden? Use Coke to clean your batteries? That type of stuff. Home made floor dry?
Posts: 62,934

11-15-2005, 03:49 PM	#106
Iowanian Supporter Join Date: Aug 2000 Location: Utopia Casino cash: $1798454	Garage door opener dilema. Ok Tool Men... I've got a garage, it has a door, it has a newer automatic opener. It was working fine, and then one day, wasn't. I can push the button(remote or one inside) and it opens just fine, when I push the close button, it comes down about 3/4 the way, goes back up and clicks/blinks 3 times. Suggestions?
Posts: 62,934

11-15-2005, 04:03 PM	#109
Iowanian Supporter Join Date: Aug 2000 Location: Utopia Casino cash: $1798454	If I hold the button from inside, it will close. If I don't hold the button through the cycle, it won't. It does have an outside entry pad, but I don't think I've ever used it. I'll check for a reset button, but don't have a clue as to redoing codes.
Posts: 62,934

11-15-2005, 04:08 PM	#110
Dinny Bossa Nova MVP Join Date: Nov 2001 Casino cash: $9990442	BRC had steps 4 and 5. They require some uh, well... er you know, probably a ladder, and some uh, I got nothin' Dinny
Posts: 5,050

11-15-2005, 04:10 PM	#111
Iowanian Supporter Join Date: Aug 2000 Location: Utopia Casino cash: $1798454	Ladder not required....I can stand in my boat which is taking up the whole thing, which gets to the problem.... To Do 21."get the garage door fixed and open for use by the family before snow falls"....oops.
Posts: 62,934

11-15-2005, 04:16 PM	#112
Dinny Bossa Nova MVP Join Date: Nov 2001 Casino cash: $9990442	At the risk of a good callin' out, you might be suffering from what we in the "industry" call a defective or worn-out garage door opener. Dinny
Posts: 5,050

11-15-2005, 04:22 PM	#113
Iowanian Supporter Join Date: Aug 2000 Location: Utopia Casino cash: $1798454	Its possible, but though I bought hte house in June, and it wasn't clarified as to the age, I don't think the opener is very old....I'd wager less than 5 years. What is the average life expectancy?
Posts: 62,934

11-15-2005, 05:09 PM	#114
Baby Lee Supporter Join Date: Aug 2000 Casino cash: $8028275	1. Loosen the door from the opener [there should be a quick release on the chain/gear] and manually run it through the problem area, see if there's a palpable snag. 2. If you have the electric eyes, make sure they're not getting misaligned or obstructed by the travel of the door. 3. Check and see if your opener has a sensitivity setting. If so, open it up a little. 4. Check your manual and see if the '3 blink' is a specific problem code. __________________ We need the kind of courage that can withstand the subtle corruption of the cynics - E.W.
Posts: 95,642

11-15-2005, 05:09 PM	#115
Dinny Bossa Nova MVP Join Date: Nov 2001 Casino cash: $9990442	I honestly don't know what the life-expectancy, but I'm sure it's tied to the quality of the unit. If you can't find a snag in the track/roller thang, be aware there is a wide gray area between completely dead and working properly. If the reset/reprogram doesn't solve it, you are likely looking at some new hardware. And of course, the lowest price is not always the greatest value. Dinny
Posts: 5,050

11-15-2005, 05:11 PM	#116
Phobia Guest Casino cash: $	Your tension spring is broken. Check the two springs on the roller above the door. One of them is broken. Do not try to repair this yourself. Call a professional.
Posts: n/a

11-15-2005, 05:21 PM	#120
FAX testing ... 1, 2, 3 Join Date: Oct 2004 Location: Tennessee Casino cash: $6753759	I have it on good authority that boogers will serve as caulk when you're in a pinch. They're oderless too. FAX THE INNOVATIVE
Posts: 44,492